The Jet Teng Models XXX ARF is an EDF jet (easily converted to Turbine) that offers high performance and very high detail. The jet is a full composite 110-120mm EDF jet that features a fiberglass wing as well as a fiberglass fuselage, fin, and stabilizer. The detail work includes panel lines and rivet detail over the entire surface of the jet. The jet comes pre painted from the factory with decals applied and a clear coat finish to protect the jet.

ConSTRUCTION INFORMATION:

Along with the cosmetic detail of the Jet Teng Models, the engineering and construction detail rivals the appearance. It is designed for 110-120mm fan units. But can also take Turbine power plants. The front air inducting is factory installed and exhaust ducting is included. Retracts are easy to install with mounts pre-installed in the nose and hatches ready for cut out in the wing. In addition, the canopy is glued together and all hatch work is done at the factory with hatch locks installed. The plane features aileron, elevator, rudder, throttle and flap function standard. Optional features would be retracts and nose gear steering. The ARF kit even comes with retract gear door covers.

SPECIFICATIONS:

Power: 110-120 mm EDF or 6-8 kg Turbine

Wing Span: 1490mm (58.5 inch)

Length: 1700mm (67 inch)

Estimated Power: 13-17 lbs

Recommended Power: 10-14S Li-Po System and Motor (Estimated based on motor)

metal EDF with Brushless Motor: (Included)

ITEMS NEEDED FOR COMPLETION:

Li-Po Battery: 10-14S 30C 4000 mAh or higher

ESC: High Voltage ESC Castle Creations Pro BEC

Servos: 6x MG for Ailerons, Flaps, Elevator

Set Up: Center of Gravity: 215mm/220mm measured from leading edge of wing at root