SkyhawkRC 3 Axis Brushless gimbal

Structure features:

1. Aluminum alloy material, half side signal frame, light and firm

2. Brushless motor direct drive.

3. Adjust center of gravity of camera, for different shot.

4. Active self stabilization, a closed loop test, stabilization more precisely

1. Support sensitivity parameter adjust and software 3D pose display.

2. Support stick speed mode and position mode

3. Support receiver: common receiver, PPM Receiver, DSM2/DSMJ/DSMX receiver.

4. Support radio:PPM/PCM/2.4Ghz

5. Working voltage: DC 7.4V-14.8V(suggest 11.1V.3S)

6. Working current: 200Ma-2A (It is depends on voltage and motor rate)

7. Working temperature:-15—65

8. CPU:MEGA328P

9. Sensor:MPU6050 Three axis servo, accelerometer

10. Max angel speed:2000/SEC

11. Max speed:16g

12. Control HZ:1600Hz

13. Motor drive rate:8/32Khz

14. Control precision:0.1

15. Control angel range:0-360

16. Control angel range:-35-35(roll); -90-90(pitch); 0-360(yaw).

17. Software: Russia Alexmos right version. it can be upgrade new firmware.

Support Camera：

SONY NEX-3n、3nl、3ny。

SONY NEX-5n、5r、5t。

SONY NEX-7、7n、7r。

Support Lens：

16F/2.8 Prime wide angle lens.16-55F Convertible lens (it is did not support convertible lens)

Shooting:

Camera gimbal cannot output film picture; should supervise it on the ground; should add HDMI

convert AV mode. The mould will be provided soon (optional)